Replacing the fuser unit, Replacing the fuser unit 107, Fuser life 107 removing a used fuser 107 – Konica Minolta Magicolor 7300 User Manual
Page 115
Advertising
Replacing the Fuser Unit
107
Replacing the Fuser Unit
CAUTION
The fuser can become extremely hot and cause severe burns.
Make sure the printer is cool before handling it
(approximately 20 minutes).
Attention
Using the wrong voltage fuser in the printer will void the fuser’s
warranty. The fuser unit’s fuse is not replaceable.
Fuser Life
When the fuser unit is worn out, the message
FUSER LOW
appears. After the
fuser unit is replaced, the printer automatically resets the consumables count.
Removing a Used Fuser
1
Turn off the printer, and then wait about 20 minutes before continuing.
2
Pull up the lock release lever to
open the right-side door.
3
Loosen the two shoulder screws,
one on each side.
Advertising