Konica Minolta Magicolor 7300 - Manual (Page 140)

Dual In-Line Memory Module (DIMM) 132
You may also need additional memory (DIMMs) for the following:
To print at maximum performance
To print complex graphics or complex PostScript documents
For increased spooling performance for duplexing and collation
Attention
It’s very important to protect the printer controller board and any
associated circuit boards from electrostatic damage. Before performing
this procedure, review the antistatic caution on page 129. In addition,
always handle circuit boards by the edges only.
1
Turn off the printer, and unplug the power cord.
Attention
Unplug the power cord from the printer, not from the outlet.
2
Press down on the two controller
access clips on the printer’s
controller access cover, and then
remove the cover.
Attention
Do not touch any electrical
parts or the controller board
on the inside of the printer
frame; otherwise, the
electronic parts of the
printer may be damaged by
static electricity from your
body.