Solving problems—printing quality 203 – Konica Minolta Magicolor 7300 User Manual
Page 211
Solving Problems—Printing Quality
203
If the problem is not resolved, even after all of the above have been
performed, contact Technical Support with the error information. See the
Service & Support Guide for a list of sources of service and support for many
areas of the world. For the most up-to-date information globally, check
The color
has a poor
reproduc-
tion or has
poor color
density.
One or more of the
print units are
defective.
Remove the print unit(s) and check for
damage. If damaged, replace it (them).
The Auto-Image
Density Control
(AIDC) detection
sensor is dirty.
Open the front door, and then press
the AIDC sensor lever a few times.
AIDC is disabled.
Check to see if AIDC Enabled is listed
on the start page.
Symptom
Cause
Solution