Konica Minolta Magicolor 7300 - Manual (Page 134)

Introduction 126
Attention
Never spray cleaning solution directly on the printer’s surface; the
spray could penetrate through the air vents of the printer and damage
the internal circuits. Avoid using abrasive or corrosive solutions or
solutions that contain solvents (such as alcohol and benzene) to clean
the printer.
Clean the printer before powering it on, or after it’s completely cooled
down.
Use a soft cloth to clean the printer.
Always test any cleaning solution (such as mild detergent) on a small area
of your printer to check the solution’s performance.
Never use sharp or rough cleaning implements, such as wire or plastic
cleaning pads.
Exterior
This item needs
cleaning... After... Use Avoid
Control panel Once a month
or as needed,
whichever
comes first. A soft, dry cloth Sharp or rough
implements (such as
wire or plastic cleaning
pads)
Any liquid
Printer exterior A soft, damp
cloth that is
firmly wrung out
(mild detergent) Sharp or rough
implements (such as
wire or plastic cleaning
pads)
Abrasive or corrosive
solutions that contain
solvents (such as
alcohol or benzene)