Antunes, AJ VCT-50 - Manual (Page 7)

VERTICAL CONTACT TOASTER
6 P/N 1010729 Rev. C 05/04
VERTICAL CONTACT TOASTER
7 P/N 1010729 Rev. C 05/04
Figure 2. Installing Bun Chute
Bun Chute
Yellow Support Rod
Hook Bun Chute over rear
bottom conveyor cover
yellow support rod
Figure 1. Installing Damper Assy.
Heat Shield
Heat Shield
Conveyor
Cover Assy.
Yellow Support
Rod
Conveyor
Cover Assy.
Conveyor
Cover Assy.
Conveyor
Cover Assy.
Unpacking
1. Remove unit and all packing materials from ship-
ping carton.
2. Open the large box. It should contain:
• Bun chute (Figure 2)
• Plastic bag containing the release sheet
(Figure 4)
3. Remove all packing materials and protective cov-
erings from the unit and parts.
NOTE: If any parts are missing or damaged, con-
tact Antunes Technical Service IMMEDIATELY at
1-877-7854-392.
Assembling the Unit
1. Remove heat shield along with front and rear
conveyor covers (Figure 1).
2. Install the damper assy. (Figure 1).
NOTE: Make sure the damper assy. rests only on
the bottom front and rear yellow support rods.
3. Install the bun chute (Figure 2).
4. Remove the release sheet from the plastic bag
and lay it on a clean, flat surface. Fold the sheet
exactly in half (Figure 3).
5. Crease the sheet at the fold using only your fin-
ger (Figure 3).
NOTE: Do not use metal tools to crease the sheet.
6. Install the release sheet by draping it over both
sides of the platen surface. The crease should
be centered directly on top of the platen (Figure
4).
7. Re-install the front and rear conveyor covers
(Figure 4).
IMPORTANT: Make sure the covers rest only on
both the top and bottom yellow support rods.
8. Install the heat shield assy. The heat shield
clips fit over the top of the platen and retains the
release sheet (Figure 4).
INSTALLATION
CAUTION
Failure to use release sheets may result in dam-
age to the unit and loss of warranty coverage.