Antunes, AJ VCT-50 - Manual (Page 8)

VERTICAL CONTACT TOASTER
8 P/N 1010729 Rev. C 05/04
VERTICAL CONTACT TOASTER
9 P/N 1010729 Rev. C 05/04
IMPORTANT: Make sure heat shield assy. is activat-
ing (depressing) the conveyor interlock switch (see
Figure 4). The conveyors will not rotate unless the
heat shield is in place and interlock switch is
activated (depressed).
NOTE: Check the release sheet to make sure it is
not caught in the conveyor. Additional release
sheets can be obtained through your authorized
service agency under part no. 7000110 (3 pack) or
7000111 (10 pack).
Equipment Setup
When placing the toaster into service, pay attention to
the following guidelines.
• Make sure power to the unit is off and the toaster
is at room temperature.
• Do not block or cover any openings on the unit.
• Do not immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do not allow cord to hang over edge of table or
counter.
Connect the unit to the power supply. Refer to the
specification plate for the proper voltage.
Figure 3. Folding Release Sheet
Lay sheet on a flat surface
Fold over so ends meet
Press lightly with finger to
form crease
Figure 4. Installing Release Sheet
Platen
Conveyor Cover
Conveyor Cover
Heat Shield
Release Sheet
Conveyor Interlock
Switch
WARNING
ELECTRICAL SHOCK HAZARD. FAILURE TO
FOLLOW THE INSTRUCTIONS IN THIS MANUAL
COULD RESULT IN SERIOUS INJURY OR DEATH.
• Electrical ground is required on this appliance.
• Do not modify the power supply cord plug. If
it does not fit the outlet, have a proper outlet
installed by a qualified electrician.
• Do not use an extension cord with this appliance.
• The toaster should be grounded according to local
electrical codes to prevent the possibility of electri-
cal shock. It requires a grounded receptacle with
separate electrical lines, protected by fuses or cir-
cuit breaker of the proper rating.
• Check with a qualified electrician if you are in
doubt as to whether the appliance is properly
grounded.
CAUTION
Bread may burn. Therefore toasters must not be
used near or below curtains or other combustible
walls and materials. Failure to maintain safe oper-
ating distances may cause discoloration or com-
bustion.
CAUTION
All electrical connections must be in accordance
with local electrical codes and any other appli-
cable codes.
INSTALLATION (continued)