Antunes, AJ VCT-50 - Manual (Page 9)

VERTICAL CONTACT TOASTER
8 P/N 1010729 Rev. C 05/04
VERTICAL CONTACT TOASTER
9 P/N 1010729 Rev. C 05/04
Operating Instructions
1. Set the bun adjustment controls (Figure 6) to the
desired settings.
NOTE: After initial run of 4-6 buns, adjust controls
according to the desired finished product.
2. Turn the rocker switch on (Figure 5).
3. Turn the temperature control to 10. Allow 30 min-
utes warm-up time before proceeding.
4. Drop buns into toaster (Figure 5). Cut sides of
heel and crown must face each other.
5. Toasted product will drop into the bun landing
area (Figure 5).
6. Test at least 4 buns before putting toaster into
service. Turn temperature control to lower setting
for lighter toasting or to higher setting for darker
toasting.
7 Turn the rocker switch off when finished toasting
Safety Features
HI-LIMIT RESET BUTTON
A hi-limit thermostat will turn off electrical power to the
heater and control circuits if the unit overheats. To
reset this thermostat, allow sufficient time (10-15 min-
utes) for the unit to cool down, then fully depress the
reset button located at the rear of the unit (Figure 5).
If the unit requires continuous resetting, contact your
Roundup authorized service agency.
CONVEYOR INTERLOCK SWITCH
A conveyor interlock switch is located on top of the unit
under the heat shield (Figure 4). The conveyors will not
rotate unless the heat shield is in place and interlock
switch is activated (depressed).
OPERATION
1
2
3
4
5
1 = 1/2"(12.7mm)
2 = 5/8"(15.9mm)
4 = 3/4"(19.1mm)
5 =13/16"(20.6mm)
6 = 7/8"(22.2mm)
THICKNESS THICKNESS
1
2
3
4
5
6
6
3 =11/16"(17.5mm)
Figure 6. Bun Thickness Adjustment Controls
1
2
3
4
5
1 = 1/2"(12.7mm)
2 = 5/8"(15.9mm)
4 = 3/4"(19.1mm)
5 =13/16"(20.6mm)
6 = 7/8"(22.2mm)
THICKNESS THICKNESS
1
2
3
4
5
6
6
3 =11/16"(17.5mm)
Figure 5. Toaster Controls
Bun Thickness
Adjustment Controls
Bun Landing
Area
Rocker Switch
Hi-Limit Reset
Temperature Control
(see Figure 6)