AEG L61271WDBI - Manual (Page 28)

WARNING!
Remove all the packaging and
the transit bolts before you install
the appliance. We recommend that you keep
the packaging and the transit
bolts for when you move the ap-
pliance.
13.2 Positioning and levelling
• Install the machine on a flat hard floor.
• Make sure that air circulation around
the machine is not impeded by car-
pets, rugs etc.
• Carefully level by screwing the adjust-
able feet in or out.
• After having levelled the appliance,
tighten the lock nuts.
• The appliance must be level and sta-
ble.
Never place cardboard, wood or
similar materials under the ma-
chine to compensate for any un-
evenness in the floor.
If it is impossible to avoid positioning
the machine next to a gas cooker or
coalburning stove, an insulating panel
covered with aluminium foil on the side
facing the cooker or stove, must be in-
serted between the two appliances.
Before placing it on small tiles, apply a
rubber coating.
The water inlet hose and the drain hose
must not be kinked.
CAUTION!
The machine must not be instal-
led in rooms where the tempera-
ture can drop below 0°C.
Raising the appliance
Suspended wooden floors are particular-
ly susceptible to vibration
. To help prevent vibration we recom-
mend you place a waterproof wood pan-
el, at least 15 mm thick under the appli-
ance, secured to at least 2 floor beams
with screws, the wood panel must ex-
tend beyond the front feet.
If possible install the appliance in one of
the corners of the room, where the floor
is more stable
28 www.aeg.com