ATTO Technology 2700C - Manual (Page 35)

ii
CLI error messages
The following error messages may be returned by the Command line Interface
ERROR. Invalid Command. Type 'Help' for command list.
ERROR. Wrong/Missing Parameters
Usage: <usage string>
ERROR Invalid RAID Group state
ERROR Invalid Block Device index
ERROR Invalid RAID Member index
ERROR Maximum number of RAID Groups exceeded
ERROR Insufficient number of RAID Group members
ERROR
Block Device at specified index no longer available
ERROR Insufficient RAID Group members for RAID type
CLI summary
The following chart summarizes the Command
Line Interface commands, their defaults, and an
example of how to enter the commands. Commands which have no default values have a
blank entry in that column of the table.
CAUTION CAUTION
Do not use CLI unless you are directed to by an ATTO technician.
Changing parameters may cause loss of data and/or disruption to performance and reliability of
the iPBridge.
The ExpressNAV interface is the preferred method to operate and manage the iPBridge. Refer to
Using ExpressNAV on page 27 for details.
Command Default Example
AccessControl disabled for default node
enabled for all other nodes set accesscontrol default enabled
AccessEntry get accessentry default all delete
AutoMap automap
BridgeModel get bridgemodel
BridgeName iPBridge set bridgename Omega6
ClearEventLog cleareventlog
ClearTraceLog cleartracelog
Date set date 03/03/2005
DeleteAllMaps deleteallmaps
DisplayEventLog displayeventlog
DisplayEventLogFilter all all all set displayeventlogfilter gen info all
DisplayTraceLog displaytracelog
DisplayTraceLogFilter all all all set displaytracelogfilter all all chkcond
DPMTU 1514 set dpmtu all 9014
DumpConfiguration dumpconfiguration
DumpEventLog dumpeventlog
DumpTraceLog dumptracelog
EmailFromAddress set emailfromaddress [email protected]