ATTO Technology 2700C - Manual (Page 8)

3
ATTO Technology Inc. iPBridge Installation and Operation Manual
1.1 ATTO iPBridge 2700R/D physical components
The ATTO iPBridge 2700R/D is a 1-Gigabit Ethernet to Fibre Channel 1U full-rack bridge for high
performance, cost effective solutions in enterprise environments.
Dimensions
Width: 17 inches
Length: 8.94 inches
Height: 1.7 inches (1U)
Weight: 8 pounds
Environment
Operating temperature: 5-40 °C external
Ambient air should not exceed 40 °C
Cooling: air enters through the slots in the rear
panel and exits through the blower on the far end
of the rear panel.
Humidity: 10-90% non-condensing
Power
Power draw: 100-260 [email protected] amps. ATTO
Technology, Inc. does not offer specific
international power cords. The power inlet on the
unit is a IEC320-C14. When selecting a cord, be
sure it meets all national safety compliance
requirements.
Battery-backed event log SRAM & Real-Time-
Clock:
A rechargeable Lithium ion battery cell
will hold the memory in a 512KB SRAM for up to
30 days.
WARNING
Risk of explosion if the battery is removed
and/or replaced by an incorrect type.
Dispose of used batteries in accordance
with your local environmental regulations.
If the iPBridge has been disconnected from
power, recharging begins automatically when
power is restored to the system. The battery is
fully charged after 24 hours of continuous power
application.
Ethernet data ports
The four independent 100/1000 Ethernet RJ-45
data ports are labeled Ethernet ports 1, 2, 3 and 4.
The data ports support IP v.4 in compliance with
IEEE 802.3 GbE. Each may also be used for
iPBridge management.
GbE cables must be at least CAT-5E certified for
1000 Mb/sec. use.
Fibre Channel data ports
The two independent optical SFP 4-Gb Fibre
Channel ports auto-negotiate to 1-, 2- or 4-Gb
devices.
Management ports
A 100 Mb/sec. Ethernet standard
RJ-45 management port and an
RS-232 serial port provide
support for remote monitoring
and management. The serial port
is set at the factory at 115,200
bps.
LED indicators
From the connector side: (see Exhibit 1.1-2):
Ready/Fault LED lights green to indicate ready,
lights yellow to show a faulted condition, and is
off to indicate not ready.
Ethernet management port: a lighted green LED
shows a valid link; off indicates that no link is
present. A separate blinking yellow LED
indicates activity.
Ethernet ports: a green light on the bicolor LED
indicates 100 Mb/sec. Ethernet speed while a
lighted yellow LED shows 1000 Mb/sec. A
separate solidly lit green LED indicates an active
link, blinking indicates activity and off shows no
link is present.
Fibre Channel ports: A lighted green LED
indicates link; off means no link. A separate green
LED indicates activity if it is lit, no activity if it is
off.
1
9
8
7
6
5
4
3
2 RX
TX
GND