0 operation / accessories – AEG MULTI-COMPRESSOR MV 10 User Manual

Page 23

Advertising
background image

23

°

Do not operate the compressor longer
than 10 minutes, then allow the unit to
cool down for 10 minutes!

Car, motorcycle- and bicycle tyres with auto-
motive valve (Schrader valve with 7.7 mm thread
diameter) can be inflated without adapter!

Image 6

Select the desired valve adapter , or .
Open the valve quick disconnect by pressing
the quick disconnect lever away from the air hose
. Now attach the valve adapter and press the
lever toward the air hose to close (see Image 6).

4.3.1 Use with the air hose and the
automotive valve connector

Check the unit and compressed air hose for
damage before every use! Do not operate dam-
aged units! Review the manufacturer instructions
for the item to be inflated before every use.

Attention! Always wear suitable ear
protectors and safety goggles during

operation!

The unit may be connected to a vehicle using the
built-in 12 V automotive plug and a vehicle or
operated with a suitable separate power station
with built-in 12 V storage battery.

4.3 Operating the compressor

Set the On / Off switch for the light to ( I ).
The light with the 4 LEDs is now switched on.

Turn the lamp head to swivel the light by
180 (see Image 5).

To switch the LED light off set the On / Off
switch for the light to ( O ).

4.2 Operating the light

Automatic start warning! If the
On / Off switch for the compressor
power is set to ( I ) before switching the

unit on, the compressor will automatically start
and compressed air will be supplied through the
air hose and to the inflating valve and air sucked
in through the suction valve. Risk of property
damage and personal injury!

Remove the 12 V automotive plug with
connector cable from the storage
compartment .

Use the 12 V automotive plug on the
12 V receptacle of a vehicle or a suitable
power station with 12 V storage battery.
The equipment is now operational and the
lighting on the manometer is activated.

To switch the compressor on set the On / Off
switch to ( I ).

To switch the compressor off set the On / Off
switch to ( O ).

4.1 Powering the equipment On / Off

4.0 OPERATION /
ACCESSORIES

3

13

13

10

17

17

1

14

14

7

4

3

8

9

GB

3

4

7

8

9

°

Image 5

Swivels
180
degrees

97181_Multi-Kompressor_MV_10_Manual _02_08_2012_Print

Donnerstag, 2. August 2012 13:03:17

Advertising