AEG MULTI-COMPRESSOR MV 10 User Manual

Page 26

Advertising
background image

26

Unscrew the retaining screw.

Remove the terminal cap and the 15 A
(Ampere) round fuse.

Reassemble all parts with the new 15 A fuse in
the order shown and replace the retaining
screw (see Image 10).

Image 10

Terminal cap

12 V plug
Vehicle
connector

Retaining screw

Round fuse 15 A (Ampere)

12 V automotive plug

4.6 Replacing fuses

Do not operate the compressor longer
than 10 minutes, then allow the unit to
cool down for 10 minutes!

Now insert the free end of the flexible pump
hose onto the compressor suction valve . Be
sure it is firmly seated.

To switch the compressor on set the compressor
switch to ( I ). Note: the compressor can be
switched off at any time by setting the com-

pressor switch to ( O ).

Once the item is deflated promptly switch the
unit off by setting the compressor switch to ( O )
and disconnect the unit from the power supply.
Avoid overloading the unit by suctioning an
already deflated item!

To deflate items open the item's valve cover.

Attach the correct size valve adapter to the
flexible pump hose and press it into the item's
valve. If the valve adapter comes off the valve
whilst deflating, use your hand to press it into
the valve whilst deflating.

Check the valve adapter is firmly seated in the
item's valve by carefully pulling on it.

4.5 Deflating with the pump hose
(flexible low pressure hose)

Attention! Please not the manufacturer
specifications for the item. Do not use the
compressor to inflate swimming aids!

Non-binding pressure guidelines
Automotive tyre

approx. 1.9 – 3.5 bar

Trailer tyre

approx. 2.4 – 3.4 bar

Motorcycle tyre

approx. 1.7 – 2.9 bar

Bicycle tyre

approx. 2.0 – 4.0 bar

Football

approx. 0.6 – 1.1 bar

Volleyball

approx. 0.18 – 0.22 bar

Remove the valve adapter from the item's valve
and attach the item's valve cap.

Then remove the flexible pump hose from the
compressor's inflating valve .

15

16

13

13

17

Image 9

Deflating

Inflating

97181_Multi-Kompressor_MV_10_Manual _02_08_2012_Print

Donnerstag, 2. August 2012 13:03:18

Advertising