AEG BS7304021M - Manual (Page 14)

WARNING!
Do not put water directly
into the steam generator.
Use only water. Do not use
filtered (demineralised) or
distilled water. Do not use
other liquids. Do not put
flammable or alcoholic
liquids into the water
drawer.
1. Prepare the food in the correct
cookware.
2. Press the cover of the water drawer
to open it.
3. Fill the water drawer with 800 ml of
water.
The water supply is sufficient for
approximately 50 minutes.
4. Push the water drawer to its initial
position.
5. Activate the appliance.
6. Select a steam heating function and
the temperature.
7. If necessary, set the function
Duration or End Time .
The first steam shows after
approximately 2 minutes. An acoustic
signal sounds when the appliance is
at approximately the set
temperature.
When the steam generator is
empty, an acoustic signal
sounds.
The signal sounds at the end of the
cooking time.
8. Deactivate the appliance.
9. Empty the water drawer after the
steam cooking is completed.
CAUTION!
The appliance is hot.
There is a risk of burns.
Be careful when you
empty the water drawer.
When the appliance cools down, soak up
all remaining water from the steam
generator with the sponge. If necessary,
clean the steam generator with some
vinegar. Let the appliance dry fully with
the door open.
6.6 Heat-up indicator
When you activate a heating function,
the bar on the display comes on. The bar
shows that the temperature increases.
6.7 Fast Heat Up Indicator
This function decreases the heat-up time.
To activate the function, hold for 3
seconds. The heat-up indicator
alternates.
6.8 Residual heat
When you deactivate the appliance, the
display shows the residual heat. You can
use the heat to keep the food warm.
7. CLOCK FUNCTIONS
7.1 Clock functions table
Clock function Application
Minute Minder To set a countdown (max. 2 h 30 min). This
function has no effect on the operation of the
appliance. You can also activate it when the
appliance is deactivated.
Use
to activate the function. Press or
to set the minutes and to start.
Duration To set the length of an operation (max. 23 h
59 min).
End Time To set the switch-off time for a heating func-
tion (max. 23 h 59 min).
www.aeg.com 14