AEG BS7304021M - Manual (Page 43)

• Clean all accessories after each use
and let them dry. Use a soft cloth with
warm water and a cleaning agent.
• If you have nonstick accessories, do
not clean them using aggressive
agents, sharp-edged objects or a
dishwasher. It can cause damage to
the nonstick coating.
12.2 Removing the shelf
supports
Before maintenance, make sure that the
appliance is cool. There is a risk of burns.
To clean the appliance, remove the shelf
supports.
1. Pull carefully the supports up and out
of the front catch.
2
3
1
2. Pull the front end of the shelf support
away from the side wall.
3. Pull the supports out of the rear
catch.
Install the shelf supports in the opposite
sequence.
12.3 Steam Cleaning
Remove the worst dirt manually.
1. Put 250 ml of water with 3
tablespoons of vinegar directly into
the steam generator.
2. Activate the function: Steam
Cleaning.
The display shows the duration of the
function. An acoustic signal sounds when
the programme is completed.
3. Touch a sensor field to deactivate
the signal.
4. Wipe out the appliance with a soft
cloth. Remove the water from the
steam generator.
Keep the appliance door open for
approximately 1 hour. Wait until the
appliance is dry. To speed up the drying
you can heat up the appliance with hot
air at temperature 150 °C for
approximately 15 minutes.
12.4 Steam generation system
CAUTION!
Dry the steam generator
after each use. Remove the
water with the sponge.
Remove the limescale with
water and vinegar.
CAUTION!
Chemical de-scaling agents
can cause damage to the
enamel. Follow the
instructions of the
manufacturer.
1. To clean the water drawer and the
steam generator, put the water and
vinegar mixture (approximately 250
ml) through the water drawer into the
steam generator. Wait for
approximately 10 minutes.
2. Remove the water and vinegar with
the sponge.
3. Put clean water (100 - 200 ml) into the
water drawer to flush the steam
generation system.
4. Remove the water from the steam
generator with the sponge and rub it
dry.
5. Keep the door open to let the
appliance dry fully.
12.5 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
ENGLISH 43