Olympus PT-014 - Manual (Page 18)

E-18
Load the digital camera.
Quietly load the digital camera into the Case, taking care that the projecting
part of the zoom lever of the digital camera properly fits into the recessed
part of the zoom lever of the Case.
Setting the Zoom Lever
When loading the digital camera in the Case, fit the projecting part of the
zoom lever of the digital camera into the recessed part of the zoom lever
on the inside of the Case.
：・When loading the camera, confirm that the projecting part of
the zoom lever of the camera is properly set to the recessed
part of the zoom lever of the Case.
・When the setting is insufficient, the loading of the camera
becomes imperfect and it may not be possible to seal the
Case or zooming may not function. Insufficient sealing will
cause water leakage.
CAUTION
E-17
Note ：・ At this time, the LCD should be left switched off to save the battery.
Open the Case.
Insert the buckle opener of the accessory into the buckle opening lever as
shown in the figure (in direction ①) Pull the buckle opener slowly (in direction
②). When not using the buckle opener, hold the buckle opening lever with
your thumb and index finger from the side and pull it up slowly.
①
②