Olympus PT-014 - Manual (Page 22)

E-22 E-21
：・ After loading the camera into the Case, confirm that the
mode dial moves. If it does not move, there is the possibility
that oil or fat has been attached to the mode dial. Please
wipe it clean.
・ When no operation is performed for three minutes after the
digital camera has been loaded (or for the specified time
when a different time has been specified), the camera
enters into sleep mode (standby status) to save battery
power. It returns to operation status when the shutter button
or the zoom lever is operated.
CAUTION
Perform the final checks.
Visual Inspection
After sealing the Case, check the sealing part of front and rear lid visually
to confirm that the O-ring is not twisted or out of the groove and that no
foreign matter has been caught.
Try to move the mode dial.
After sealing, turn the mode dial knob and confirm that the mode dial of the
camera is switched.
：・Hairs, fibers, and other narrow items are not very apparent, but
they may cause entry of water, so that special attention is required.
CAUTION