Olympus PT-014 - Manual (Page 6)

Handling the Product
● Use or storage of the product at the following locations may cause
defective operation, defects, trouble, damage, fire, internal clouding, or
water leakage. Always avoid these locations.
・ Locations reaching high temperatures such as those under direct
sunlight, in an automobile, etc.
・ Locations with open fire
・ Water depths in excess of 40 m
・ Locations subject to vibrations
・ Locations with high temperatures and much dust or with severe
temperature changes
・ Locations with volatile substances
● This product is made of polycarbonate resin with excellent impact
resistance, but it may be damaged by scraping against rocks etc. It also
may break when it hits hard objects or is dropped.
● This product is not a case to soften impacts to the camera inside the
product. When this product with a digital camera inside it is subjected to
impacts or heavy objects are placed onto it, the digital camera may
become damaged. Please handle the product with sufficient care.
● When the product is not used for a long time, the waterproof performance
may drop because of deterioration of the O-ring etc. Before use, always
perform the advance test and the final check.
● Do not apply excessive force to the tripod socket.
● When a flash is used while the Case is being used, shadows may appear
at the edges of the picture. This is especially notable when taking pictures
in macro mode on the wide-angle side. Please use a flash after image
confirmation.
８．When the O-ring contact surface is pressed strongly from the outside of
the Case, or when the Case is twisted, the waterproof function may be
lost. Take care not to exert excessive force.
９．Please use the Case after performing the advance test and the final
check.
If you should notice drops of water or other signs of water leakage while
taking pictures, immediately stop the dive, remove any water from the
camera and the product, test according to the item "Final check", and
confirm whether leakage has occurred or not.
E-5
１０．
E-6