Boss Audio Systems BR-600 - Manual (Page 24)

24
Panel Descriptions
Re
v0.10
1
Make sure that the power of the BR-600 is turned off.
2
Turn over the BR-600.
3
Slide the battery cover in the direction indicated by
the arrow and remove.
4
Being careful not to reverse the polarity (+/-), insert
six AA dry-cell batteries into the battery
compartment.
fig.00-100
5
Replace the battery cover.
Inserting Batteries
• When turning the unit upside-down, get a bunch
of newspapers or magazines, and place them
under the four corners or at both ends to prevent
damage to the buttons and controls. Also, you
should try to orient the unit so no buttons or
controls get damaged.
• When turning the unit upside-down, handle with
care to avoid dropping it, or allowing it to fall or
tip over.
• BOSS recommends using longer-life alkaline
batteries.
• Do not mix new batteries with partially used
batteries, and do not mix batteries of differing
types.
• Do not use rechargeable batteries.
• When the battery power becomes low, “Battery
Low!” appears in the display. When this message
appears, replace the existing batteries with new
ones as soon as possible.
• Continuous battery life varies according to usage
conditions and the type of battery used. It is also
affected by the CompactFlash type and capacity.