Boss Audio Systems BR-600 - Manual (Page 82)

82
Editing the Performance on a Track (Track Edit)
Re
v0.10
6
Press [ENTER].
fig.02-450
7
Use [CURSOR] and the TIME/VALUE dial to specify
the time of the beginning of the location “T” (To)
where you want the data to be moved.
8
When you are ready to execute the move, press
[ENTER].
The display will ask “Are you sure?,” so that you can
confirm the operation.
9
Press [ENTER].
Move Event is executed.
10
Press [UTILITY] (or press [EXIT] repeatedly) to
return to the Play screen.
* During updating, “Keep power on!” appears in the upper
line of the display, while the lower line shows what is being
processed.
Track Erase allows you to erase a specific part of data. Even
if data exists after the specified part, it will not be moved
forward to fill the gap left by the erasure. Like a normal
tape recorder, erasing can be considered covering
unwanted data by recording emptiness.
Perform the procedure given below to erase the portion
between specific times.
fig.02-500
1
Confirm that [PAD] is not lit, then press [UTILITY].
2
Press CURSOR [ ] [ ] to move the cursor to
“TRK,” and press [ENTER].
fig.02-510
Erasing Data (Track Erase)
■ Erasing by specifying the
time (TME/MES)
Do not leave a portion of less than 1.0 seconds in length
after the erased portion. If a portion that short does
remain, it will end up being silent.
START END Time