Bench Dog Tools Phenolic ProPlates - Manual (Page 19)

benchdog.com
©Copyright Bench Dog Tools, Inc. 2008
Toll Free 800-786-8902 page 19
r
outer table accessories
Mounting to aftermarket fences
(like Fasttrack or Woodhaven). Mounting to a shop-made or scrap
wood fence.
Mounting T-Loc to your fence makes installing Panel-Loc simple and tool-free.
T-Loc mounted to a simple
shop-made fence. Installation
is easy — just screw it on.
Panel-Loc was developed in
conjunction with acclaimed
woodworker Lonnie Bird,
pictured above in his woodshop. The unique design of
Panel-Loc
places downward pressure on your workpiece at just the right
place — 2" away from the fence. This prevents the tipping that
occurs with ordinary featherboards.
Panel-Loc also provides
excellent protection from accidental contact with the router bit, and
its long surface area protects you from flying chips and dust.
Panel-Loc includes a 20" length of our T-Loc accessory track for
mounting to most available fences. Fits ALL Bench Dog Tools
router tables.
With ProRiser , you can extend
the height of your fence to
whatever dimension you like!
Just slide the
ProRiser brackets
into the rear T-slot of your
Profence and add a piece of
3/4" thick stock. The stock can
be very wide for maximum
support, or it can be a specific
width to allow surface moldings
to slide through un-obstructed.
Includes all necessary hardware;
you just add the fence face.
T-Loc is a horizontal 1/4"
accessory T-track. The T-slot
captures 1/4" hex-head bolts used on
many aftermarket accessories. Use
T-Loc to add a
T-slot to your shop-made fences and jigs. T-Loc has many other
uses too, such as a guide, holding stops, or other fixtures. T-Loc is
the best way to attach our Feather-Loc featherboards and other
Bench Dog Tools accessories to your shop-made fence. T-Loc can
also be mounted to many other brands of router table fences. T-Loc
may also be an effective way to add a horizontal T-track to your
table saw’s rip fence. Comes in 36" lengths. May be cut to size.
Mounting will require drilling holes and obtaining proper hardware.
➤
Maximum support for routing boards on edge and for raising panels vertically.
➤
Holds material perfectly square to the table — ideal for precise joinery.
➤
Works with ANY Bench Dog Tools router table.
➤
Protects your hands from large bits!
➤
Fits ALL Bench Dog Tools router tables and fences, as well as most other router table fences.
➤
Holds your panel down firmly for better cuts and completely eliminates unwanted lifting.
➤
Low-friction, UHMW hold-down strip allows your panel to move freely and is non-marring.
➤
For all horizontal raised panel bits.
Give your ProFence a boost in height and performance!
Safer, better results when raising panels!
Stock No. 40-025
U.S. Patent No. 6,481,472
Stock No. 40-013
Developed with
expert input from
Lonnie Bird!
Stock No. 10-013
19 Dog 08 SH 2/4/08 3:04 PM Page 1