Bench Dog Tools Phenolic ProPlates - Manual (Page 6)

benchdog.com
©Copyright Bench Dog Tools, Inc. 2008
Toll Free 800-786-8902 page 6
job site tools
MEASURE
Tape measure hook slots
make measuring all those
difficult inside-to-inside
miters easy. Measure, mark,
cut and install all the trim
pieces at once. No more
tedious trial and error!
MARK AND CUT
Trim-Loc will quickly
become your tool of choice
for marking 45° and 90° cuts
and 3/16" reveals for trim.
Also makes a handy square
for checking your angles.
INSTALL
Positions and holds trim
while you nail it. Get perfect
alignment, tight-fitting miter
joints and consistent reveals
every time!
Measuring wide openings by yourself is easy! Tack
Trim-Loc in place with two 6d finish nails and slip
your tape in the slot!
How do you measure inside-
to-inside miters? Simple.
Fasten Trim-Loc to your
bench for an easy-to-use jig. Notch allows you to align
Trim-Loc with outside of
trim and extend your line
to the baseboard.
Accurately mark 3/16"
reveals around window
and door jambs Measuring wide openings
by yourself is easy! Trim-Loc is the perfect
tool for setting up and
truing saw blades, jambs
and trim.
➤
Get consistent casement reveals for a
professional look.
➤
Increase speed and efficiency.
➤
Measure inside-to-inside miters quickly
and accurately.
➤
Reduce waste and costly splits.
➤
Use as a handy combination square.
➤
Ergonomic design, easy-to-use and durable.
Installing door or window trim?
You need Trim-Loc!
Available in 5-packs
Stock No. 10-017
Workbench
mounting holes.
Starter nail guide
helps prevent splits.
Tape measure
hook slots
45° 90°
6d tack
holes.
Finger holes for
easy handling
Measure, mark, position, nail — Trim-Loc
makes it easy to get sharp results!
Stock No. 10-016
Trim-Loc is the only tool on the market used to measure, mark
and install casement trim. With this handy, lightweight tool in your belt,
trimwork will go like clockwork.
Trim-Loc’s built-in tape measure hook slots and
preset reveal allow you to accurately measure all of your trim pieces at once, saving you hours
of time. After you measure and record the trim lengths, use
Trim-Loc to accurately transfer the
measurements to your trim stock and mark cut lines. Finally, use Trim-Loc to hold the trim
pieces in perfect alignment while you nail them in place. Trim-Loc holds the trim fast,
preventing the nail gun from throwing it out of alignment. Use the starter nail guide to help
prevent costly splits and wasted material.
For better convenience and efficiency, purchase two Trim-Locs : one for your tool belt and one
for mounting to your bench — a must for carpentry crews and large trim jobs. Trim-Loc has
many other uses, too. For example, use Trim-Loc’s precise 45° and 90° guides to mark cut
lines, square jambs and true power tools. Trim-Loc is a perfect companion for your miter saw
because it’s easy to hold and doesn’t get in the way. Once you see how handy Trim-Loc is,
we’re sure it will become your tool belt favorite!
06 Dog 08 SH 2/4/08 2:46 PM Page 1