Blanco BC 75 X - Manual (Page 23)

23
Installation
Important
This cooker must be installed by qualified
personnel.
The manufacturer will not accept liability,
should the above instructions or any of the
other safety instructions incorporated in this
book be ignored.
Regulations
This appliance shall be installed in
accordance with the manufacturer’s
installation instructions, local gas fitting
regulations, municipal building codes,
AS5601 (AG601) and any other relevant
statutory regulations.
Data label
The data label is located centrally on the
front frame of the cooker below the oven.
This appliance is suitable for Natural or
Universal LPG. Ensure that the gas supply
matches the data label.
Ventilation
Ventilation must be in accordance with
AS5601 (AG601) Installation Code. In
general, the appliance should have
adequate ventilation for complete
combustion of gas, proper flueing and to
maintain temperature of immediate
surroundings within safe limits.
Connection to the gas
supply
Gas connection must be carried out in
conformity with the regulations in force. The
appliance leaves the factory tested and
regulated for the type of gas indicated on
the plate which is situated in the lower
position near the gas connection tube.
Ascertain that the type of gas with which
the appliance will be supplied is the same
as that indicated on the plate.
If different carry out all the operations
according to the indications cited in the
paragraph “adaption to different types of
gas”.
For a maximum output and minimum
consumption ascertain that the pressure of
the gas used has the values indicated in
the table of “burner characteristics”.
The joint is mounted on the intake area of
the pipe, fitted with a filleted nut GJ 1/2,
between the sealing components. Screw
the parts without forcing, turn the joint in
the direction required and then tighten
everything.