Pioneer AVIC-HD1BT - Manual (Page 27)

25
Ch
ap
te
r
2
Ba
sic O
p
era
tio
n
NA
V
I
➲ Refer to after the Step 2 of “Checking the
entire route overview at the map” ➞ Page 28
(9) Adding and editing the waypoint
You can add/remove or sort waypoints.
➲ “Editing Waypoints” ➞ Page 28
When the route guidance starts
Touching [OK] in “Route Confirmation screen”
starts the route guidance on the displayed route.
Your navigation system gives you the following
information with the timing adjusted to the speed
of your vehicle:
• Distance to the next turning point
• Direction of travel
• Road number of the motorway
• Arrival of waypoint (If waypoints are set)
• Arrival of your destination
❒ Touching or allows you to turn the
voice guidance on or off.
❒ Touching allows you to hear the
information again.
❒ If you stop at a petrol station or a restaurant
during the route guidance, your navigation
system remembers your destination and route
Information. When you start the engine and
get back on the road, the route guidance
resumes.
❒ If you deviate from the route with guidance set
to [Street List Mode] or [Mixed Mode] and
enter a street not recorded on the hard disk
drive, the screen changes to [Map Mode].
When you return to the route, returns to the
original view and resumes route guidance.
Basic items on the guidance
This section describes only the basic items that
are displayed on the Map Mode screen.
➲ Details of the map screen ➞ Page 31
(1) Current location
(2) Distance to the destination
(3) Estimated time of arrival (default)
(4) ON/OFF key of voice guidance
Cancelling the Route Guidance
If you no longer need to travel to your destination
or if you want to change your destination, follow
the steps below to cancel the route guidance.
1
Touch [Destination] in the navigation
menu, then touch [Cancel Route].
The message confirming whether to cancel
the current route appears.
2
Touch [Yes].
The current route is deleted, and a map of
your surroundings reappears.
On this screen, you can also select the follow-
ing items:
Skip:
Skip the route to the selected waypoint, and
the route is recalculated. (The skipped way-
point will not be deleted.)
No:
Returns to the previous display without delet-
ing the route.
(1) (3) (2) (4)
MAN-HD1BT-SOFTW-EN.book Page 25 Thursday, April 20, 2006 3:47 PM