Pioneer VSX-1019AH-K - Manual (Page 30)

Connecting your equipment 03
30
En
Connecting AM/FM antennas
Connect the AM loop antenna and the FM wire
antenna as shown below. To improve reception
and sound quality, connect external antennas
(see Connecting external antennas below).
1 Pull off the protective shields of both AM
antenna wires.
2 Push open the tabs, then insert one wire
fully into each terminal, then release the tabs
to secure the AM antenna wires.
3 Fix the AM loop antenna to the attached
stand.
To fix the stand to the antenna, bend in the
direction indicated by the arrow (fig. a) then
clip the loop onto the stand (fig. b).
• If you plan to mount the AM antenna to a
wall or other surface, secure the stand with
screws (fig. c) before clipping the loop to
the stand. Make sure the reception is clear.
4 Place the AM antenna on a flat surface
and in a direction giving the best reception.
5 Connect the FM wire antenna in the same
way as the AM loop antenna.
For best results, extend the FM antenna fully
and fix to a wall or door frame. Don’t drape
loosely or leave coiled up.
Connecting external antennas
To improve FM reception connect an external
FM antenna to the FM UNBAL 75
Ω.
To improve AM reception, connect a 5 m to 6 m
length of vinyl-coated wire to the AM LOOP
terminals without disconnecting the supplied
AM loop antenna.
For the best possible reception, suspend
horizontally outdoors.
AM
LOOP
FM
UNBAL
75
ANTENNA
3
1 2
4
5
fig. a fig. b fig. c
AM
LOOP
FM
UNBAL
75
ANTENNA
75 Ω coaxial cable
AM
LOOP
FM
UNBAL
75
ANTENNA
Outdoor
antenna
5 m to 6 m
Indoor antenna
(vinyl-coated wire)
VSX-1019_SVYXJ.book 30 ページ ２００９年２月１７日 火曜日 午前１１時１３分