The advanced mcacc menu 10 – Pioneer VSX-1019AH-K User Manual
Page 83
The Advanced MCACC menu
10
83
En
1
Select ‘Fine SP Distance’ from the
Manual MCACC setup menu.
2
Adjust the distance of the left channel
from the listening position.
3
Select each channel in turn and adjust the
distance as necessary.
Use
/ to adjust the delay of the speaker
you selected to match the reference speaker.
The delay is measured in terms of speaker
distance from 0.01m to 9.00m.
Listen to the reference speaker and use it to
measure the target channel. From the listening
position, face the two speakers with your arms
outstretched pointing at each speaker. Try to
make the two tones sound as if they are
arriving simultaneously at a position slightly in
front of you and between your arm span.
1
When it sounds like the delay settings are
matched up, press
to confirm and continue
to the next channel.
• For comparison purposes, the reference
speaker will change depending on which
speaker you select.
• If you want to go back and adjust a
channel, simply use
/ to select it.
4
When you’re finished, press RETURN.
You will return to the Manual MCACC setup
menu.
Note
1 • If you can’t seem to achieve this by adjusting the distance setting, you may need to change the angle of your
speakers very slightly.
• For better audibility, the subwoofer emits a continuous test tone (oscillating pulses are heard from your other
speakers). Note that it may be difficult to compare this tone with the other speakers in your setup (depending on the
low frequency response of the reference speaker).
1. Fine Channel Level
2. Fine SP Distance
3. Standing Wave
1c.Manual MCACC
4. EQ Adjust
5. EQ Professional
A/V RECEIVER
Exit
Return
A/V RECEIVER
Exit
Cancel
MCACC : M1.MEMORY 1
Reference Ch :
L
1c2.Fine SP Distance
Ref.Ch Distance :
3.61m
A/V RECEIVER
Exit
Finish
R
<=>
L
L :
3.61m
1c2.Fine SP Distance
R :
3.67m
C :
3.69m
SR :
2.74m
SL :
2.26m
SBL : 5.13m
SBR : 5.77m
SW : 3.54m
VSX-1019_SVYXJ.book 83 ページ ２００９年２月１７日 火曜日 午前１１時１３分