Pioneer PDP-LX5090 - Manual (Page 20)

Watching TV 06
20
En
Chapter 6
Watching TV
Important
• Before watching broadcast channels, the built-in TV tuner must
be set up. See Setting up TV channels on page 27 for how to do
this.
Turning the power on
• Turn a on on the flat screen TV when the POWER ON and
STANDBY indicators are off (see
Part names on pages 12 and
13).
• The system is on.
• The POWER ON indicator lights up blue.
• Press a or 0 to 9 on the remote control unit or STANDBY/ON
on the flat screen TV if the STANDBY indicator lights red.
• The POWER ON indicator lights up blue.
• If you press 0 on the remote control unit, images from “INPUT 1”
will be displayed.
• If you press 1 to 9, TV images will be displayed.
Placing the system into standby
Press a on the remote control unit or STANDBY/ON on the flat
screen TV.
• The STANDBY indicator lights up red.
• The system enters the standby mode and the image on the
screen disappears.
Note
• When a on the flat screen TV is off, you cannot turn the power on
by pressing a or 0 to 9 on the remote control unit or STANDBY/
ON on the flat screen TV.
• It is recommended not to unplug the flat screen TV from a power
outlet when it is not in use. When in the standby mode, the flat
screen TV automatically receives Electronic Programme Guide
and DTV Auto Update signals.
• When the system is placed into standby mode, the main power
flow is cut and the system is no longer fully operational. A minute
flow of power feeds the system to maintain operational readiness.
• If you are not going to use the flat screen TV for a long period of
time, be sure to remove the power cord from the power outlet.
• If you unplug the flat screen TV from a power outlet, the clock
inside the flat screen TV will reset with certain functions, such as
timer recording, are disabled. After plugging in the flat screen TV
again, clock information is automatically obtained as you tune in
a DTV programme.
If you unplug the flat screen TV from a power outlet when a timer
recording programme(s) has been registered, the flat screen TV
may automatically tune in to the DTV programme in order to
obtain clock information when you turn the power on the next
time.
It may take a short while until the clock information is obtained.
An alert will appear when you try to tune in an analogue
programme before obtaining the clock information.
Flat screen TV status indicators
The table below shows the operational status of the flat screen TV.
You can check the current status of the system with the indicators
on the flat screen TV.
For other than the above, see Troubleshooting on page 82.
4 5 6
7 8 9
0
1 2 3
TV/DTV
HDMI
CTRL
INFO
PC
1 2 3 4
5
TV
INPUT
4 5 6
7 8 9
0
1 2 3
TV
Indicator status System status
POWER ON STANDBY
The power cord of the flat screen TV
has been disconnected. Or, the power
cord of the flat screen TV has been
connected but the
a button of the flat
screen TV is off.
Power to the system is on
The system is in the standby mode
PDP-LX6090.book Page 20 Monday, February 25, 2008 10:08 AM