Pioneer AVIC-60D-2 - Manual (Page 151)

149
Chapter
6
Combining and Using Pioneer A
V
Equipment
1 Press
5 or ∞ to select “NON FADING” from the AUDIO MENU, and press A.MENU
(AUDIO) button.
When the subwoofer controller setting is “S.W. CONTROL:EXTERNAL”, you can
select non fading output on/off mode.
2 Press
5 to turn non fading output on.
➲
You can turn off non fading output by pressing
∞.
3 Press
2 or 3 to adjust the output level of the non fading.
Each press of
2 or 3 increases or decreases the level of the non fading (e.g., +6 to -6).
■Using the high pass filter
When you do not want low sounds from the subwoofer output frequency range to play from
the front or rear speakers, switch the HPF (high pass filter) on. Only frequencies higher than
those in the selected range are output from the front and rear speakers.
1 Press
5 or ∞ to select “HPF (HIGH PASS FILTER)” from the AUDIO MENU, and press
A.MENU (AUDIO) button.
2 Press
5 to turn high pass filter on.
➲
To turn high pass filter off, press
∞.
3 Press
2 or 3 to select a high pass filter range.
Press
2 and FREQUENCY:50 Hz is displayed. Press 3 and 80 Hz, 125 Hz is displayed.
Only frequencies higher than those in the selected range are output from the front or rear
speakers.
➲
If you switch the SFEQ mode, the HPF (HIGH PASS FILTER) function is automatically
switched off. By switching the HPF (HIGH PASS FILTER) function on after selecting the
SFEQ mode, you can combine HPF (HIGH PASS FILTER) function with SFEQ function.
■Adjusting source levels
SLA (Source level adjustment) lets you adjust the volume level of each source to prevent rad-
ical changes in volume when switching between sources.
➲
Settings are based on the volume level of the FM tuner, which remains unchanged.
1 Compare the FM tuner volume level with the level of the source you wish to adjust.
2 Press
5 or ∞ to select “SLA (SOURCE LEVEL ADJUSTMENT)” from the AUDIO
MENU, and press A.MENU (AUDIO) button.
3 Press
5 or ∞ to adjust the source volume.
Each press of
5 or ∞ increases or decreases the source volume.
➲
LEVEL:+4 - LEVEL:-4 is displayed as the source volume is increased or decreased.
➲
Since the FM tuner volume is the control, it is not possible to apply source level adjust-
ments to the FM tuner.
➲
The MW/LW tuner volume level can also be adjusted with source level adjustments.
➲
The CD and the multi-CD players are both set to the same source level adjustment volume
automatically when using the AVH-P6400CD.
➲
External unit 1 and External unit 2 are set to the same volume adjustment setting automati-
cally.