Pioneer AVIC-70D - Manual (Page 108)

106
Messages and how to react to them
The following messages may be displayed by your Navigation System.
➲
There are occasions when you may see error messages other than those shown here. In
such a case, follow the instructions given on the display.
(1) “You cannot use this function while driving.”
When:
While trying to make a menu selection.
What to do:
Pull over and come safely to a halt, put the handbrake on, and then try again.
(2)“This is not the appropriate disc. Please insert the appropriate disc.”
When:
(1) If you try to use a disc which is incompatible with this system.
(2) If you insert a disc upside down.
(3) If the disc is dirty.
(4) If the disc is cracked or otherwise damaged.
What to do:
(1) Insert a suitable disc.
(2) Insert the disc with the label upward.
(3) Clean the disc.
(4) Consult your dealer.
(3)“Irregular speed pulse signal is detected. Please turn system power off and check the
installation. After checking, please re-boot the system.”
When:
If the Navigation unit does not receive the vehicle speed pulse.
What to do:
Consult your Pioneer dealer.
(4) “Speed pulse wire is not connected. Please be sure to connect the system to the
speed pulse wire. Accuracy is not fully ensured without speed pulse.”
When:
The speed signal input (pink lead wire) of the power wire is not connected.
What to do:
To operate with 3D hybrid mode, connect the speed signal input (pink lead wire) of the power wire cor-
rectly. Although it can be operated with Simple hybrid mode without connecting the speed signal input,
the precision of the positioning will be less accurate (see “Positioning by dead reckoning” on page
97).
(5) “Vibration is detected. Please turn system power off and check the installation. After
checking, please re-boot the system and press “OK” .”
When:
While the car is stationed, the Navigation System is installed at the place where the main unit may be
affected by a large vibration.
What to do:
Re-install the main unit of the Navigation System to the place where the main unit will not be affected by
vibration.