Pioneer AVIC-F860BT - Manual (Page 188)

Message Cause Action
Already stored. This tag information is already
stored in memory. Tag information can only be saved once for
any given song. Tag information cannot be
saved for the same song more than once.
Memory full. Connect iPod. The tag information is successfully
stored. The flash memory of this
product has become full. The tag information on this product is trans-
ferred to the iPod automatically when an iPod
is connected.
Memory full. Tags not stored.
Connect iPod. This product
’s flash memory used
as the temporary storage area is
full.
The tag information on this product is trans-
ferred to the iPod automatically when an iPod
is connected.
iPod full. Tags not transferred. Memory used for tag information on
the iPod is full.
Sync the iPod with iTunes and clean up the
tagged playlist.
Tag transfer failed. Reconnect
your iPod. This product
’s tag information can-
not transfer to the iPod.
Check the iPod and try again.
Bluetooth
Message Cause Action
Error-10 The power failed for the Bluetooth
module of this product. Turn the ignition switch to OFF and then to
ON.
If the error message is still displayed after per-
forming the above action, please contact your
dealer or an authorised Pioneer Service Sta-
tion.
MirrorLink
Message Cause Action
The application list could not
be read out. Failed to load the application list. ! Disconnect the cable from the smartphone,
and then connect the smartphone again after
a few seconds.
! Turn the ignition switch to OFF and then to
ON.
If the error message is still displayed after per-
forming the above action, reset the smart-
phone.
If the error message is still displayed after per-
forming the above action, please contact your
dealer or an authorised Pioneer Service Sta-
tion.
There is no supported applica-
tion on your MirrorLink de-
vice. No supported applications can be
found. Install MirrorLink compliant applications to
your MirrorLink device.
Engb
188
Appendix
Appendix