Pioneer X-CM42BTD-W - Manual (Page 18)

iPod/iPhone/iPad playback 05
18
En
2 Set up to stand the iPod/iPhone/iPad.
When using an iPod/iPhone
Make sure the iPod/iPhone cable is aligned along the groove
for it on the back of the stand that comes with the unit.
When using iPad
Make sure to place the iPad in a horizontal direction on the
stand.
Playing iPod/iPhone
1 Connect your iPod/iPhone.
If an iPod/iPhone is connected when this unit is on, playback
of the iPod/iPhone will not begin.
2 Press iPod or USB as the input source.
“IPOD” or “USB/IPOD” is shown on the main display.
3 When the recognition is completed, will
begin playing automatically.
Playing iPad
1 Connect your iPad.
If an iPad is connected when this unit is on, playback of the
iPad will not begin.
2 Press USB as the input source.
“USB/IPOD” is shown on the main display.
3 When the recognition is completed, will
begin playing automatically.
CAUTION
• When your iPod/iPhone/iPad is connected to this unit
and you wish to operate the iPod/iPhone/iPad directly,
be sure to steady the iPod/iPhone/iPad with the other
hand to prevent malfunctions due to faulty contacts.
Note
• iPod/iPhone/iPad recharging occurs whenever an iPod/
iPhone/iPad is connected to this unit. (This function is
supported in standby mode as well.)
• When input is switched from iPod to another function,
iPod/iPhone/iPad playback is temporarily stopped.
• When iPod/iPhone/iPad is not playing and no operations
have been performed for more than 20 minutes, the unit
will automatically power off.
• Auto power off can be switched to ON/OFF (page 38).
Important
• If this unit cannot play your iPod/iPhone/iPad, perform
the following troubleshooting checks:
- Check whether the iPod/iPhone/iPad is supported by
this unit.
- Reconnect the iPod/iPhone/iPad to the unit. If this
doesn’t seem to work, try resetting your iPod/iPhone/
iPad.
- Check the iPod/iPhone/iPad software is supported by
this unit.
• If the iPod/iPhone/iPad cannot be operated, check the
following items:
- Is the iPod/iPhone/iPad connected correctly?
Reconnect the iPod/iPhone/iPad to the unit.
- Is the iPod/iPhone/iPad experiencing a hangup? Try
resetting the iPod/iPhone/iPad, and reconnect it to the
unit.
Back of stand
iPod/iPhone
cable
X-CM32_VXE8_En.book 18 ページ ２０１４年３月１２日 水曜日 午後２時５２分