Pioneer AVH-X7500BT - Manual (Page 58)

Setting Demo Mode
Once Demo Mode is turned on, the Demo
screen appears.
Refer to Demo mode on page 8.
1 Press the home button to switch to the
home display.
2 Touch the system key to open the sys-
tem menu.
3 Touch Demo mode on the system menu
to turn Demo mode on or off.
! On – The Demo screen appears.
! Off – The Demo screen does not appear.
Switching sound muting/
attenuation
Sound from this system is automatically
muted or attenuated when a signal from
equipment with a mute function is received.
! Sound from this system returns to normal
when the muting or attenuation is can-
celed.
1 Press the home button to switch to the
home display.
2 Touch the system key to open the sys-
tem menu.
3 Touch Mute/ATT until the desired set-
ting appears.
Touch
Mute/ATT until the desired setting ap-
pears in the display.
! Mute – Muting
! ATT –20dB – Attenuation (ATT –20dB has a
stronger effect than ATT
–10dB)
! ATT –10dB – Attenuation
! Off – Turns the sound muting/attenuation
off
Notes
! When Mute is displayed, the sound is turned
off and no audio adjustments can be made.
! When ATT is displayed, the sound is attenu-
ated and only the volume can be adjusted.
(No other audio adjustments can be made.)
! Operation returns to normal when the phone
connection is ended.
Setting the rear output and
subwoofer controller
This unit
’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
Full) or subwoofer
( Subwoofer) connection. If you switch the
rear output setting to Subwoofer, you can
connect a rear speaker lead directly to a sub-
woofer without using an auxiliary amp.
Initially, the unit is set for a rear full-range
speaker connection (
Full).
1 Turn the source off.
Refer to Turning the source ON/OFF on page
10.
2 Press the home button to switch to the
home display.
3 Touch the system key to open the sys-
tem menu.
4 Touch Rear Speaker on the system
menu to switch the subwoofer output or
full-range speaker.
# When no subwoofer is connected to the rear
output, select
Full (full-range speaker).
# When a subwoofer is connected to the rear
output, select
Subwoofer (subwoofer).
Notes
! Even if you change this setting, there will be
no output unless you turn the subwoofer out-
put on (refer to Using subwoofer output on
page 50).
! Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
En
58
Section
17 System settings