Pioneer AVH-X7500BT - Manual (Page 75)

iPod
Message Cause Action
Format Read Sometimes there
is a delay be-
tween the start of
playback and
when you start to
hear any sound. Wait until the mes-
sage disappears
and you hear
sound.
Error-02-6X/-
9X/-DX Communication
failed. Disconnect the
cable from the
iPod. Once the
iPod
’s main menu
is displayed, recon-
nect the iPod and
reset it.
iPod failure. Disconnect the
cable from the
iPod. Once the
iPod
’s main menu
is displayed, recon-
nect the iPod and
reset it.
Error-02-67 The iPod firm-
ware version is
old. Update the iPod
version.
Stop There are no
songs. Transfer songs to
the iPod.
There are no
songs in the cur-
rent list. Select a list that
contains songs.
Not Found No related
songs. Transfer songs to
the iPod.
iTunes tagging
Message Cause Action
iPod full. Tags
not trans-
ferred. Memory used for
tag information
on the iPod is
full. Sync the iPod with
iTunes and clean
up the tagged play-
list.
Memory full.
Tags not
stored. Con-
nect iPod. This unit
’s flash
memory used as
the temporary
storage area is
full.
The tag informa-
tion on this unit is
transferred to the
iPod automatically
when an iPod is
connected.
Tag transfer
failed. Recon-
nect your
iPod. This unit ’s tag in-
formation cannot
transfer to the
iPod.
Check the iPod
and try again.
Message Cause Action
Tag store
failed. Tag information
cannot be stored
in this unit. Try again.
Error-8D Built-in FLASH
ROM encoun-
tered an error. Turn the ignition
OFF or ON.
Already
stored This tag informa-
tion is already
stored in mem-
ory. Tag information
can only be saved
once for any given
song. Tag informa-
tion cannot be
saved for the same
song more than
once.
Bluetooth
Message Cause Action
Error-10 The power failed
for the Bluetooth
module of this
unit. Turn the ignition
switch OFF and
then to ACC or ON.
If the error mes-
sage is still dis-
played after
performing the
above action,
please contact
your dealer or an
authorized Pioneer
Service Station.
Understanding auto EQ
error messages
When correct measurement of the car
’s inter-
ior acoustic characteristics is not possible
using auto EQ, an error message may appear
on the display. In such cases, refer to the table
below to see what the problem is and how it
may be corrected. After checking, try again.
En
75
Appendix
Additional
information
Additional information