Pioneer AVH-X7500BT - Manual (Page 8)

About this manual
! This unit features a number of sophisti-
cated functions to ensure superior recep-
tion and operation. All the functions have
been designed for the easiest possible use,
but many are not self-explanatory. This op-
eration manual will help you benefit fully
from this unit
’s potential and to maximize
your listening enjoyment.
! This manual uses diagrams of actual
screens to describe operations. However,
the screens on some units may not match
those shown in this manual depending on
the model used.
! In the following instructions, USB memory
sticks and USB audio players are collec-
tively referred to as
“USB storage device”.
! In this manual, iPod and iPhone will be re-
ferred to as
“iPod”.
If you experience problems
Should this product fail to operate properly,
please contact your dealer or nearest author-
ized Pioneer Service Station.
Protecting your unit from
theft
The front panel can be detached to deter theft.
Important
! Handle the front panel with care when remov-
ing or attaching it.
! Avoid subjecting the front panel to excessive
shock.
! Keep the front panel out of direct sunlight and
high temperatures.
! If removed, replace the front panel on the unit
before starting up your vehicle.
! To avoid damaging the device or vehicle inter-
ior, remove any cables and devices attached
to the front panel before detaching it.
Removing the front panel
% Pinch the top and bottom of its right
side and pull the front panel out.
Take care not pinch it too tightly or to drop it,
and also avoid contact with water or other
fluids to prevent permanent damage.
Re-attaching the front panel
1 Slide the front panel to the left.
The front panel and the head unit are con-
nected on the left side. Make sure that the
front panel has been properly connected to
the head unit.
2 Press the right side of the front panel
until it is firmly seated.
# If you can’t attach the front panel to the head
unit successfully, try again. Forcing the front
panel into place may result in damage.
Demo mode
The feature demo automatically starts when
you select
Off for the source and continues
while the ignition switch is set to ACC or ON.
To cancel the feature demo, press and hold
MUTE. Press and hold MUTE again to restart.
Operating the feature demo while the car en-
gine is turned off it may drain the battery
power.
Important
The red lead (ACC) of this unit should be con-
nected to the ignition on/off function. Failure to
do so may result in battery drain.
En
8
Section
02 Before you start