Pioneer MEH-P9100R - Manual (Page 67)

66
ENGLISH
ESPAÑOL
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
Switching the Rear Speaker Output (Rear Speaker Out)
This product’s rear speaker leads can be used for full-range speaker (“Full Range output”)
or Subwoofer (“Sub woofer output”) connection. If you switch Rear Speaker Lead setting
to the “Sub woofer output”, you can connect a rear speaker lead directly to a Subwoofer
without using an auxiliary amp.
Note:
• When no Subwoofer is connected to the rear speaker lead, select “Full Range output”.
• Even if you change to “Sub woofer output”, there is no output unless you switch the Subwoofer
Output (refer to page 51) in the Audio Menu 2 ON.
Setting the Subwoofer Control (Sub woofer control)
When rear speaker leads are connected to full range speakers (when “Full Range output” is
selected), you can connect the RCA subwoofer output to a Subwoofer. In this case, you
can select whether to use the Subwoofer controller’s (Low Pass Filter, Phase) built-in
“Internal” or the auxiliary “External”.
Note:
• When the Rear Speaker Output is “Sub woofer output”, you cannot change the Subwoofer
Controller.
• If you change the Subwoofer Controller, Subwoofer output and Non-Fading output in the Audio
Menu 2 return to the factory settings.
• Even if you change this setting, there is no output unless you switch the Non-Fading Output (refer
to page 53) or Subwoofer Output (refer to page 51) in the Audio Menu 2 ON.
2. Change the Subwoofer
Controller with the
2/3 but-
tons.
1. Press the FUNCTION button and select the Sub woofer Control mode
(Sub woofer control) in the Initial Setting Menu.
2. Select the desired Rear
Speaker Out with the
5/∞ but-
tons.
1. Press the FUNCTION button and select the Rear Speaker Output mode
(Rear Speaker Out) in the Initial Setting Menu.