Pioneer X-SMC3-K - Manual (Page 29)

Changing the settings 12
29
En
English
Français
Español
2 Select Timer Setting.
The Timer Setting screen is displayed.
3 Use /// or number buttons to adjust
the clock, then press ENTER.
The TIMER indicator lights and the wake-up timer has been
set.
• Using / moves the adjusting digit (hour/minute/
AM, PM 1 ).
• Using / increases or decreases values.
• If you press RETURN, the previous screen will be
displayed.
• The wake-up timer will turn on an input source at the
volume level you selected when you set the timer.
Turning on/off the wake-up timer
2
1 Press to turn on the timer.
The TIMER indicator lights.
• To turn off the timer, press during the timer is on.
Using the wake-up timer
1 Set the wake-up timer to on.
2 Press STANDBY/ON to turn the power off.
3 At the wake-up time, this unit will turn on
automatically and play the selected input
function.
If this unit is not operated for 60 minutes or more after
playback is started by the wake-up timer, power will
automatically turn off (standby mode).
Using the sleep timer
The sleep timer switches off the unit after a specified time so
you can fall asleep without worrying about it.
1 Press SLEEP repeatedly to select a switch off
time.
Choose between 5 min, 15 min, 30 min, 60 min, 90 min or Off. 3
Network setting
If a broadband router (with built-in DHCP server function) is
connected to this unit, you can simply turn on the DHCP
server function without having to set up the network
manually. A broadband router without a DHCP server
function connected to this unit must be set up as described
below. Before you set up the network, consult with your ISP or
the network manager for the required settings.
It is advised that you also refer to the operation manual
supplied with your network component.
• Any changes made to a router without the DHCP server
function must be reflected to unit network settings.
1 Press SET UP.
The Initial Setup screen is shown on the main display.
2 Select Network Setting  Network
Configuration.
3 Use / to select Wired Setting or Wireless
Setting, then press ENTER.
Next steps are described separately between Wired Setting
and Wireless Setting. Follow the instructions of the
appropriate network type.
Note
1 The “AM” and “PM” indicators appear only when the Time Format is set to the 12H mode.
2 Timer Setting need to be done before you turn on the timer.
3 The sleep timer can be set by pressing SLEEP while the remaining time is displayed.
Timer Setting
7 0 AM
H:M AM/PM
Wired Setting
Wireless Setting
Network Configuration
X-SMC3_SYXZT8_En.book 29 ページ ２０１１年６月９日 木曜日 午後４時６分