13 additional information, Troubleshooting, Additional information – Pioneer X-SMC3-K User Manual

Page 34: Additional information 13, Chapter 13

Advertising
background image

Additional information

13

34

En

Chapter 13:

Additional information

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this
component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components
and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your
nearest Pioneer authorized service center or your dealer to carry out repair work.

• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug from the

outlet and insert again to return to normal operating conditions.

General problem

When an iPod/iPhone is connected

Problem

Check

Remedy

Settings you have made have
been cleared.

Was the power cord unplugged
forcibly while this unit’s power was
on?

Be sure to press STANDBY/ON on this unit’s top panel or press
STANDBY/ON on the remote control and wait for the POWER ON
indicator on the front panel display to turn off before unplugging
the power cord.

Difference in volume
between MP3, WMA, iPod/
iPhone and Tuner.

This is not a problem with this unit.

The volume may sound differently depending on the input source
and recording format.

This unit cannot be operated
with the remote control.

Are you operating from far away?

Operate from within a distance of Operate within 7 m, 30° of the
remote sensor on the front panel (page 5).

Is the remote control sensor exposed
to direct sunlight or strong artificial
light from a fluorescent bulb, etc.?

The remote control signals may not be received properly if the
remote control sensor is exposed to direct sunlight or strong
artificial light from a fluorescent bulb, etc.

Are the batteries dead?

Replace the batteries (page 5).

Picture is stretched, or
aspect ratio cannot be
switched on TV.

Is the aspect ratio properly set on the
connected TV?

Refer to the TV’s operating instructions and set the TV’s aspect ratio
properly.

The unit automatically turns
off or the demonstration
screen automatically starts.

Is Auto mode select set to Power
Save mode
or Demo Mode?

Change the setting of Auto mode select to Off (page 28).

Problem

Check

Remedy

Can’t operate the iPod/
iPhone.

Make sure the iPod/iPhone is connected correctly (refer to
Connecting your iPod/iPhone on page 14).
Also, try disconnecting the iPod/iPhone then reconnecting it.
If the iPod/iPhone is experiencing a hangup, try resetting the iPod/
iPhone, and reconnect it to the unit.

X-SMC3_SYXZT8_En.book 34 ページ 2011年6月9日 木曜日 午後4時6分

Advertising
This manual is related to the following products: