Pioneer DVH-P590MP - Manual (Page 50)

Notes
! Up to 42 characters can be displayed on one
line. If more than 42 characters are set, the
line breaks and the characters are displayed
on the next line.
! Up to 126 characters can be displayed on one
screen. If more then 126 characters are set,
the excess characters will not be displayed.
Setting for digital output
Audio which is outputted from digital output
of this unit can be selected. Normally, set to
STREAM. If this unit
’s digital output is not
used, there is no need to change settings.
! Selecting LPCM enables you to switch the
output channel if playing the following type
of discs. (Refer to Selecting audio output on
page 24.)
— Dual mono mode DVD video discs
— Bilingual DVD-VR discs
1 Move the joystick up or down to select
DIGI OUT.
2 Click the joystick.
The digital output setting is displayed.
3 Move the joystick left or right to select
the desired digital output setting.
! STREAM – The Dolby Digital/DTS signal is
output as it is (initial setting)
! LPCM – The Dolby Digital/DTS signal is con-
verted to and output as a linear PCM signal
4 Click the joystick.
The selected digital output setting is
determined.
Initial Settings
Adjusting initial settings
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press FUNCTION and hold until function
name appears in the display.
3 Press FUNCTION to select one of the in-
itial settings.
Press
FUNCTION to select one of the initial
settings.
CLOCK AJST (clock)
—OFFCLK (off clock)—
FM STP (FM tuning step)
—AUTOPI (auto PI
seek)
—WARN (warning tone)—AUX1 (auxili-
ary input1)
—AUX2 (auxiliary input2)—V.IN
(AV input setting)
—CAMRA (rear view camera
setting)
—R-SP (rear output and subwoofer
controller)
—E-SCRL (ever scroll)—TITLE (multi
language)
—TV (TV signal setting)—D.ATT (di-
gital attenuation)
—A.RESET (audio reset)
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down
FUNCTION until the unit turns off.
# When you select CAMRA in V.IN, you can se-
lect
CAMRA.
# When the multi-channel processor (e.g., DEQ-
P6600) is connected to this unit, you can operate
D.ATT and A.RESET instead of R-SP.
Setting the clock
Use these instructions to set the clock.
Operating this unit
En
50
Section
03