Pioneer DVH-P590MP - Manual (Page 55)

Using the AUX source
This unit can control an auxiliary equipment
such as VCR or portable device (sold sepa-
rately). When connected, auxiliary equipment
is automatically recognized as AUX source
and assigned to
AUX.
About AUX connection method
You have two methods to connect auxiliary
equipments to this unit.
Mini pin plug cable (AUX1)
When connecting auxiliary equipment using a
mini plug cable
iPod and portable audio/video player can be
connected to this unit via mini plug cable.
! If an iPod with video capabilities is con-
nected to this unit via 3.5 mm plug (4 pole)
cable (e.g., CD-V150M), you can enjoy the
video contents of the iPod.
! It is possible to connect a portable audio/
video player by using a 3.5 mm plug (4
pole) to RCA cable, which is sold sepa-
rately. However, depending on the cable, re-
verse connection between Red (right side
audio) cable and yellow (video) cable is re-
quired. Otherwise, audio and video may not
be correctly reproduced.
% Insert the mini plug into the micro-
phone/auxiliary input jack on this unit.
IP-BUS-RCA interconnector (AUX2)
When connecting auxiliary equipment using an
IP-BUS-RCA Interconnector (sold separately)
% Use an IP-BUS-RCA Interconnector such
as the CD-RB20/CD-RB10 (sold separetely)
to connect this unit to auxiliary equipment
featuring RCA output.
For more details, refer to the IP-BUS-RCA Inter-
connector owner
’s manual.
# You can only make this type of connection if
the auxiliary equipment has RCA outputs.
Selecting AUX as the source
% Press SOURCE to select AUX (AUX1 or
AUX2) as the source.
# If the auxiliary setting is not turned on, AUX
cannot be selected. For more details, see Switch-
ing the auxiliary setting on page 51.
Setting the AUX title
The title displayed for each AUX1 or AUX2
source can be changed.
1 After you have selected AUX as the
source, press FUNCTION and hold until
TITLE IN appears in the display.
2 Enter a title in the same way as the
built-in DVD player.
For details concerning operation, refer to En-
tering disc titles on page 36.
Switching between digital and
analog
When this unit is connected to the DEQ-
P6600, you can switch to the AUX mode to
analog or digital.
1 Press SOURCE to select AUX2 as the
source.
Press
SOURCE until AUX2 appears in the dis-
play.
# If the auxiliary setting is not turned on, AUX2
cannot be selected. For more details, see Switch-
ing the auxiliary setting on page 51.
2 Press BAND to switch the modes.
Press BAND repeatedly to switch between the
following modes:
ANALOG (analog)
— DIGITAL (digital)
Note
When this unit is connected to the DEQ-P6600,
you can switch to the AUX mode to analog or di-
gital. However, when you use
AUX2 as the
source, make sure the AUX mode is set to analog.
AUX digital should not be used with this unit.
Operating this unit
En
55
Section
03
Operating
this
unit