Pioneer ANH-P10MP - Manual (Page 22)

Setting the Navigation
En 21
<CRD3863-A> 22
Calibration
Before using the navigation, perform calibration
and language definition referring to the
Installation Manual.
After switching on the unit, the status of the
GPS antenna or of the GPS reception will be
indicated on the right of the display. Four differ-
ent messages may appear:
•
GPS OK : The navigation CD can be inserted.
GPS reception is already available.
• GPS WAIT: It is necessary to wait for GPS
reception. Waiting is required until GPS OK is
displayed (vehicle must be outdoors). The
navigation CD can be inserted.
• GPS ANTENNA ERROR: The GPS antenna is
not properly connected.
• GPS MODULE ERROR: If this message is dis-
played, please contact your local Pioneer
dealer.
1 Insert the navigation CD to install the
software for the navigation system.
2 After installing the navigation software,
press the NAVI/OK button.
The next display appears.
3 Press the BACK button to access the
system settings.
The language selection is then requested.
4 Select the language using the rotary
stick.
The language selection is confirmed by press-
ing the
NAVI/OK button and the language is
installed.
5 Select the voice using the rotary stick.
You can choose either a male or a female voice
for some languages.
The voice is confirmed and installed by pressing
the
NAVI/OK button.
6 After installation, press the NAVI/OK but-
ton to confirm.
CRD3863A_inst_002-029_UK 4/9/04 2:05 PM Page 22