Pioneer SEP-C1 - Manual (Page 12)

12
En
PARTS AND THEIR FUNCTIONS
Display A/Display B
1 Track number display
“DJS” is displayed during DJS control.
2 TEMPO control range display (±6, ±10, ±16, WIDE)
Displays the selected variable range mode of the
TEMPO
adjust slider.
3 TEMPO change ratio display
Displays the change in tempo produced by the operation of the
TEMPO adjust slider.
4 A.CUE indicator
Lights when the Auto Cue function is ON.
5 Time display
Displays the current track’s elapsed time ([
REMAIN] indicator
is off), or remaining time ([ REMAIN] indicator is lighted), in
minutes [ M], seconds [S], and frames [F].
6 Playing address display
To provide a quick intuitive grasp of the relative progress of a
track’s playback (either elapsed time or remaining time), a bar
graph is used to represent the full length of the track.
• Elapsed time display: Starts with all segments off, then
gradually lights from left to right.
• Remaining time display: Starts with all segments on, then
gradually goes off from left to right.
• When 30 seconds of remaining playing time is reached, the
graph begins to flash slowly.
• When 15 seconds of remaining playing time is reached, the
graph begins to flash quickly.
7 BPM display
Shows the currently playing track’s BPM (Beats Per Minute)
8 MEMO indicator
Not displayed during DJS control.
9 REMAIN indicator
Lights when the time display is set for remaining time.
REAR PANEL
1 PC connector: USB port (type B)
Use the accessory USB cable to connect this port to a
computer.
2 5 V connector
Use the accessory USB auxiliary power cable to connect to a
computer.
3 Video output connector (MONITOR OUT)
Use a video cable to connect to an external display.
4 Remote control connector (REMOTE CONTROL)
Not used with this unit.
1
8
4 6
2
7
3 5 9
PC
MONITOR OUT
5V
REMOTE
CONTROL
1
2
3
4
SEP-C1_EN.book 12 ページ ２００８年３月２４日 月曜日 午前１０時５２分