Pioneer VMS-550 - Manual (Page 13)

English
Français
Español
Italiano
Deutsch
Nederlands
Pyccкий
7
En
Notes on battery charging
• Battery performance is influenced by the surrounding temperature. Charge the
supplied rechargeable batteries within a temperature range of 5 to 35 degrees
celsius.
• Do not overcharge batteries. In order to protect batteries, do not repeatedly
charge the batteries that are already fully charged.
• Batteries become slightly warm when charging. This is not a malfunction.
• Use only the supplied AC adaptor with this unit. Using other AC adaptors may
cause malfunction.
• For your safety, only the supplied rechargeable batteries can be charged by
this unit. Do not use other types of rechargeable or dry-cell batteries.
• Rechargeable batteries should be replaced with new ones when they last only
a short time after recharging. New batteries can be ordered from your nearest
Pioneer authorized service centre.
• During recharging, sound is not produced from the speaker even if the
speaker’s power switch is turned on.
• The speaker’s POWER indicator normally lights green during use, but when
the battery’s remaining charge is low, the indicator flashes green. If the
indicator begins flashing, the speaker should be recharged as soon as
possible.
• If the speaker is only used for short periods of time, the battery should not be
recharged until it is allowed to discharge completely. If the battery still allows
only a short operating time after full recharging, the battery may have reached
the end of its lifetime.
By connecting this unit to a television or AV component, you can listen to the TV/
AV component’s sound through this unit’s speakers. For details regarding
connections, read the TV/AV component’s operating instructions.
1 Listening to audio using only this unit’s speakers
Connect the headphone output jack of the TV/AV component to the
transmitter’s input cord (see Figure 2-3.1).
Sound will cease to be output from the TV/AV component and will be output
from this unit’s speakers alone.
• If this unit is connected to Mono TV, sound will be produced from the unit’s left
speaker only.
• If the TV/AV component’s controls are used to adjust the sound volume, the
sound volume from the speakers will change. If the volume is raised to an
excessive level in this way, sound from the speakers may be distorted. In this
case, first lower the volume using the TV/AV component controls, then raise
the volume by using the speaker’s controls.
2-3 Connecting up
Note