Pioneer VSX-820-K - Manual (Page 15)

Controls and displays 02
15
En
English
Français
Deutsch
Nederlands
Italiano
Español
SB CH
Press to select
ON, AUTO, OFF the
surround back channel.
CH SELECT
Press repeatedly to select a channel, then
use
LEV +/– to adjust the level (page 45).
LEV +/–
Use to adjust the channel level.
EQ
Press to switch on/off Acoustic Calibration
EQ setting (page 37).
MIDNIGHT
Switches to Midnight or Loudness
listening (page 39).
SPEAKERS
Use to change the speaker system
(page 20).
PHASE
Press to switch on/off Phase Control
(page 36).
DIMMER
Dims or brightens the display. The
brightness can be controlled in four steps.
13  SOURCE
Press to turn on/off other components
connected to the receiver (see page 56 for
more on this).
14 TV CONTROL buttons
These buttons are dedicated to control the TV
assigned to the
TV button. Thus if you only
have one TV to hook up to this system assign it
to the
TV button (see page 55 for more on this).

Use to turn on/off the power of the TV.
INPUT
Use to select the TV input signal.
CH +/–
Use to select channels.
VOL +/–
Use to adjust the volume on your TV.
15 MASTER VOLUME +/–
Use to set the listening volume.
16 MUTE
Mutes/unmutes the sound.
17 DISP
Switches the display of this unit. The listening
mode, sound volume, Pre Out setting or input
name can be checked by selecting an input
source.
1
18 SHIFT
Press to access the ‘boxed’ commands (above
the buttons) on the remote. These buttons are
marked with an asterisk (
* ) in this section.
Note
1 The Pre Out setting may or may not be displayed, depending on the input source you have selected.
VSX-820_SYXCN_En.book 15 ページ ２０１０年４月１２日 月曜日 午後６時５２分