Usb messages, Resetting the main unit, Additional information 11 – Pioneer VSX-820-K User Manual
Page 79
Additional information
11
79
En
English
Français
Deutsch
Nederlands
Italiano
Español
USB messages
Resetting the main unit
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this.
1
Switch the receiver into standby.
2
While holding down the BAND button,
press and hold the
STANDBY/ON button
for about two seconds.
3
When you see RESET? appear in the
display, press AUTO/DIRECT.
OK? shows in the display.
4
Press STEREO/ALC to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory default
settings.
Symptom
Cause
Action
iPod/USB Error 1
(I/U ERR1)
There is a problem with the signal path
from the USB to the receiver.
Switch off the receiver and reconnect
the USB to the receiver.
iPod/USB Error 3
(I/U ERR3)
When there is no response from the USB. Switch off the receiver and reconnect
the USB to the receiver.
iPod/USB Error 4
(I/U ERR4)
The power requirements of the USB
device are too high for this receiver.
Switch off the receiver and reconnect
the USB to the receiver.
VSX-820_SYXCN_En.book 79 ページ ２０１０年４月１２日 月曜日 午後６時５２分 79