Pioneer DV-696AV-S - Manual (Page 15)

Connecting up 02
15
En
• Connect the multi-channel audio
outputs on this player to the multi-channel
audio inputs on your AV receiver.
It’s convenient to use three stereo audio
cables; one for the
FRONT , one for the
SURROUND and one for the CENTER and
SUBWOOFER channels.
You can use the SCART AV connector, or the S-
video or component video jacks to connect to
the AV receiver if you prefer.
Tip
• After connecting up and switching on, you
should change the Audio Output Mode
setting in the Initial Setup menu from the
default
2 Channel to 5.1 Channel . See
also Audio Output Mode on page 45.
Connecting the digital output
This player has both optical and coaxial-type
digital audio outputs for connection to an AV
receiver. Connect whichever is convenient.
Depending on the capabilities of your AV
receiver, you might have to set up this player to
output only digital audio in a compatible
format. See
Digital Audio Out settings on
page 39 and refer to the operating instructions
that came with your AV receiver.
Note that SACD audio is not output through
these jacks, so this connection should be in
addition to, rather than instead of, a 5.1
channel analog connection.
• Connect one of the DIGITAL AUDIO OUT
jacks on this player to a digital input on
your AV receiver.
For an optical connection, use an optical cable
(not supplied) to connect the
OPTICAL
DIGITAL AUDIO OUT jack to an optical input
on your AV receiver.
For a coaxial connection, use a coaxial cable
(similar to the supplied video cable) to connect
the
COAXIAL DIGITAL AUDIO OUT jack to a
coaxial input on your AV receiver.
S-VIDEO OUT AUDIO OUT (5.1ch) COMPONENT VIDEO OUT
VIDEO OUT
P R
P B
Y
L
R HDMI OUT C
SW S L
S R
AV receiver MULTI-
CH. INPUTS
COAXIAL AUDIO OUT OPTICAL DIGITAL
AC IN
AV CONNECTOR (RGB) TV/AV Receiver
AV receiver
DIGITAL IN
(OPTICAL)
DIGITAL IN
(COAXIAL)
DV696AV_WV_EN.book 15 ページ ２００６年４月７日 金曜日 午後９時４７分