Pioneer DV-696AV-S - Manual (Page 57)

Additional information 08
57
En
Cannot output 96kHz or
88.2kHz digital audio. • Check that Linear PCM Out is set to Down Sample Off (page 39).
• Some discs are digital copy protected and do not output high
sampling rate digital audio. In this case the output is automatically
downsampled.
No DTS audio output. • If this unit is connected to a non-DTS compatible amplifier or
decoder using a digital audio cable, set
DTS Out to DTS > PCM
(page 39). If you do not do this, noise will be output when you play a
DTS disc.
• If this unit is connected to a DTS-compatible amplifier or decoder
using a digital audio cable, check the amplifier settings, and that the
cable is properly connected.
Audio mix does not
sound right or sounds
incomplete (for example,
inaudible dialog). • Make sure that Audio Output Mode is set to 2 Channel if you've
connected to the stereo inputs on your amplifier or TV (page 47).
The audio recorded on a
Super VCD disc is not
output properly. • If the audio is switched to [2] when playing a Super VCD that
contains only one stereo soundtrack, there may be no sound at all.
Press
AUDIO to change the soundtrack.
Can’t hear effect of
Virtual Surround. • Virtual Surround does not work with SACD or DVD-Audio.
• The Virtual Surround effect is only output through the
AUDIO OUT
(2ch) analog audio outputs.
• Make sure that Audio Output Mode is set to 2 Channel (page 47).
• The effectiveness of Virtual Surround varies with the disc.
Problem Remedy
DV696AV_WV_EN.book 57 ページ ２００６年４月７日 金曜日 午後９時４７分