Pioneer DV-696AV-S - Manual (Page 56)

Additional information 08
56
En
No audio, or audio is
distorted. • No audio is output during slow motion playback or when scanning
discs other than audio CDs and SACDs.
• Some DVD discs do not output digital audio: Switch your amplifier
to the player's analog outputs.
• Check that the disc is free from dust and dirt, and that it is not
damaged (page 51).
• Check that all interconnects are firmly inserted.
• Check that the plugs and terminals are free of dirt, oxide, etc. and
clean if necessary. Also check the cable for damage.
• Make sure the player's output is not connected to the amplifier's
phono (turntable) inputs.
• Check your amplifier/receiver’s settings (volume, input function,
speaker settings, etc.).
The analog audio is OK,
but there appears to be
no digital audio signal. • Make sure that the Digital Out setting is set to On (page 39).
• Check that the Dolby Digital, DTS and MPEG out settings (page 39)
are suitable for your amplifier/receiver—check the instruction manual
that came with your amplifier/receiver.
• SACDs and DVD-Audio discs do not output digital audio. Listen
through the player’s analog audio outputs.
Noticeable difference in
DVD and CD volume. • This is due to differences in the audio format and is not a
malfunction.
Cannot play multi-
channel audio. • Make sure that Audio Output Mode is set to 5.1 Channel
(page 47).
• Check that the Dolby Digital, DTS and MPEG Out settings (page 39)
are suitable for your amplifier/receiver—check the instruction manual
that came with your amplifier/receiver.
• DVD-Audio and SACDs do not output multichannel digital audio.
Listen through the player’s analog outputs.
• Check that the settings in the Speaker Installation screen are
correct (page 50).
• Check the audio options available from the disc menu.
Cannot listen to high-
sampling rate audio
through the digital
output. • Make sure that Linear PCM Out is set to Down Sample Off
(page 39).
• As a copy-protection measure, some DVDs do not output 96kHz
audio. In this case, even if set to
Down Sample Off , the player
automatically outputs the audio at 48 kHz. This is not a malfunction.
Cannot output 192kHz or
176.4kHz digital audio. • The player does not output digital audio at these sampling rates. The
digital output is automatically downsampled.
Problem Remedy
DV696AV_WV_EN.book 56 ページ ２００６年４月７日 金曜日 午後９時４７分