Pioneer DEH-P88RS-II - Manual (Page 58)

Initial (initial)
—Custom (custom)—AutoTA
(auto-time alignment)
—OFF (off)
! Initial is the factory supplied time align-
ment.
! Custom is an adjusted time alignment that
you can create for yourself.
! AutoTA is the time alignment created by
auto TA and EQ. (Refer to Auto TA and EQ
(auto-time alignment and auto-equalizing)
on page 67.)
# Please set Auto TA appears. This indicates
that you cannot select
AutoTA if auto TA and EQ
has not been carried out.
Adjusting the time alignment
You can adjust the distance between each
speaker and the selected position.
! An adjusted time alignment is memorized
in Custom.
1 Use MULTI-CONTROL to select TA 1.
TA1 appears in the display.
2 Press MULTI-CONTROL to select a unit
of distance.
Each press of
MULTI-CONTROL selects the
unit of distance in the following order:
(cm) (centimeter)
—(inch) (inch)
3 Use MULTI-CONTROL to select TA2.
TA2 appears in the display.
# Can't Adjust TA. Set POS FL/FR appears
when neither
Front Left nor Front Right is se-
lected in the position selector mode ( POSI).
# When selecting OFF in TA1, you cannot
switch to
TA2.
4 Push MULTI-CONTROL left or right to
select the speaker to be adjusted.
Each time
MULTI-CONTROL is pushed left or
right, the speaker is selected in the following
order:
Hi L (high-range left)
—Hi R (high-range right)
—Mid L (middle-range left)—Mid R (middle-
range right)
—Low L (low-range left)—Low R
(low-range right)
Front L (front left) —Front R (front right)—
Rear R (rear right)
—Rear L (rear left)—
SubW. L (subwoofer left)
—SubW. R (subwoo-
fer right)
# You cannot select SubW. L and SubW. R
when the subwoofer output is off.
5 Push MULTI-CONTROL up or down to
adjust the distance between the selected
speaker and the listening position.
Each time
MULTI-CONTROL is pushed up or
down, the distance increases or decreases.
400.0cm to 0.0cm is displayed as the distance
is increased or decreased, if you have selected
centimeters (
(cm)).
160inch to 0inch is displayed as the distance
is increased or decreased, if you have selected
inches (
(inch)).
# You can adjust the distance for the other
speakers in the same way.
6 Press BAND to cancel the time align-
ment mode.
About the network
function
The network function lets you divide the audio
signal into different frequency bands, and
then reproduce each of them through sepa-
rate speaker units.
You can then make precise adjustments to the
reproduced frequency band (with a low-pass
filter or high-pass filter), level, phase and other
parameters to match the characteristics of
each speaker unit.
Audio Adjustments
En
58
Section
12