Pioneer DEH-P88RS-II - Manual (Page 63)

2 Push and hold MULTI-CONTROL down
to mute the selected speaker unit (filter).
MUTE is displayed.
# To cancel the muting, push MULTI-CONTROL
up.
Setting the high pass filter for
front speakers
1 Use MULTI-CONTROL to select F.HPF 1.
F.HPF 1 appears in the display.
2 Push MULTI-CONTROL left or right to
select slope.
Each time
MULTI-CONTROL is pushed left or
right, slopes are selected in the following
order:
–12— –6—Pass (0) (dB/oct.)
# If you set the slope to 0 dB/oct. (Pass), the
audio signal bypasses the filter, so the filter does
not have an effect.
3 Turn MULTI-CONTROL to select F.HPF 2.
F.HPF 2 appears in the display.
4 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each time
MULTI-CONTROL is pushed left or
right, cut-off frequencies are selected in the
following order:
50
—63—80—100—125—160—200 (Hz)
Only frequencies higher than those in the se-
lected range are output from the front speak-
ers.
5 Push MULTI-CONTROL up or down to
adjust the output level of the front speak-
ers.
Each time
MULTI-CONTROL is pushed up or
down, the level of the front speakers increases
or decreases.
±0 to –24 is displayed as the
level is increased or decreased.
Setting the high pass filter for
rear speakers
1 Use MULTI-CONTROL to select R.HPF 1.
R.HPF 1 appears in the display.
2 Push MULTI-CONTROL left or right to
select slope.
Each time
MULTI-CONTROL is pushed left or
right, slopes are selected in the following
order:
–12— –6—Pass (0) (dB/oct.)
# If you set the slope to 0 dB/oct. (Pass), the
audio signal bypasses the filter, so the filter does
not have an effect.
3 Turn MULTI-CONTROL to select R.HPF 2.
R.HPF 2 appears in the display.
4 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each time
MULTI-CONTROL is pushed left or
right, cut-off frequencies are selected in the
following order:
50
—63—80—100—125—160—200 (Hz)
Only frequencies higher than those in the se-
lected range are output from the rear speak-
ers.
5 Push MULTI-CONTROL up or down to
adjust the output level of the rear speak-
ers.
Each time
MULTI-CONTROL is pushed up or
down, the level of the rear speakers increases
or decreases.
±0 to
–24 is displayed as the
level is increased or decreased.
Audio Adjustments
En
63
English
Section
12