Toshiba Qosmio F20 (PQF22) - Manual (Page 70)

3-14 User’s Manual
Getting Started
Starting Hibernation Mode
To enter Hibernation mode, follow the steps below.
1. Click start.
2. Select Turn Off Computer.
3. Open the Turn Off Computer dialog box. Hibernate is not displayed.
4. Press the Shift key. The Standby item will change to Hibernate.
5. Select Hibernate.
Automatic Hibernation
The computer will enter Hibernate mode automatically when you press the
power button or close the lid. First, however, make the appropriate settings
according to the steps below.
1. Click start and open the Control Panel.
2. Open Performance and Maintenance and open Power Options.
3. Select the Hibernate window in the Power Options Properties,
select the Enable hibernation check box and click the Apply button.
4. Open TOSHIBA Power Saver.
5. Select the Setup Action window.
6. Enable the desired Hibernation settings for When I press the power
button and When I close the lid.
7. Click the OK button.
Data save in Hibernation Mode
When you turn off the power in Hibernation Mode, the computer takes a
moment to save current memory data to the hard disk. During this time,
the HDD indicator will light.
After you turn off the computer and memory is saved to the hard disk,
turn off the power to any peripheral devices.
You can also enable Hibernation Mode by pressing Fn + F4.
Refer to Chapter 5, The Keyboard , for details.
Do not turn the computer or devices back on immediately. Wait a moment
to let all capacitors fully discharge.