BodyCraft BCG-GX - Manual (Page 11)

STEP 5 ASSEMBLE SEAT FRAME AND SEAT & BACK PAD
1. Attach Seat Frame (9) to Front Upright (3), using three 3/8" X 3" Hex Bolts (99) six 3/8" Washers (116) and
three 3/8" Nylon Nuts (124).
2. Attach Seat Back Adjuster (12) to Front Upright (3), using one 3/8" X 3" Hex Bolt (99), two 3/8" Washers (116)
and one 3/8" Nylon Nut (124). It may be necessary to tighten this bolt, then loosen just enough to let Seat
Back Adjuster (12) pivot FREELY. Longer Red Pop Pin (85) should seat into adjustment holes in Seat Back
Adjuster (12).
3. Attach Leg Holder (16) to Seat Back Adjuster (12), using two 5/16" X 1/2" Round Hex Bolt (104) and two 5/16"
Washers (117). Tighten these screws.
4. Slide the two Metal Hinges (24), holes at bottom, onto the axle welded to the top of the Seat Back Adjuster
(12), then attach the Back Pad (48) to the Metal Hinges using two 3/8" X 1" Hex Threaded Bolts (103), and
two 3/8" Washers (116).
5. Attach Leg Extension Handle (6) to Seat Adj. Frame (8), using two 3/8" X 3" Hex Bolts (99), four 3/8" Washers
(116) and two 3/8" Nylon Nuts (124). Attach Seat Pad (47) to Seat Adj. Frame (8), using two 3/8" X 1-3/4"
Hex Bolts (102) and two 3/8" Washers (116).
6. Insert a 25 X 50mm Rect. End Plug (68) into each end of the Seat Adj. Frame (8) and then slide the Seat Adj.
Frame (8) into the Seat Frame (9). The Seat Adj. Frame (8) is held in place by a Locking Spring Knob (84).
7. Attach Leg Extension Arm (10) to Seat Frame (9), by inserting Leg Extension Axle (31). Fasten Leg
Extension Axle (31) using two 5/16" X 5/8" Set Screws (108), two 5/16" Spring Washers (119), and two 5/16"
Washers (117).
8. Insert a Foam Roller Holder (27) into the tube on the chrome Seat Adj. Frame (8). Slide a Plastic Cover (71)
onto the Foam Roller Holder (27), flat side to the outside. Then slide a Foam Pad (49) onto the Foam Roller
Holder (27), flat side to the outside. Cover with an Aluminum Cap (72) and secure with a 5/16"' X 1-1/4"
Sunken Head Screw (106). Repeat for the other side.
Repeat this process for Foam Pads (49) on Leg
Extension Arm (10) and Leg Holder (16).